Unsupported Screen Size: The viewport size is too small for the theme to render properly.

Soil

Rain, mud and rebuilding

Rain, Mud and Rebuilding

Rain, Mud and Rebuilding

Rain and muddy lots

With rain in the immediate forecast, we felt it was important to put together a blog post on the impact those rains could have. The key to building a home timely is to get the foundation installed as rapidly as possible before the onset of extended rainy weather. With many lots in Coffey Park needing grading and soil compaction, there must be dry weather for a period of time to get that proper compaction and to avoid mud. The dry time will vary from lot to lot and will also depend on how saturated the ground is.

The concrete foundation and slab are more forgiving with water and can even cure when it rains. However, construction workers do not work when it is pouring rain. A light drizzle and a light amount of mud will not stop them. Heavy rain and a muddy job site will stop the project.

After the foundation has cured

Once the foundation and slab are cured, the project will only slow or stop for heavy rain. Even framing the house will be fine because wood can get wet, with little impact. Once the roof is on, the house is “dried in” and there will be no slow down in the schedule.

by Matthew Gill, professional home builder, who lost his home several years ago to wildfire in Southern California.  Gill is the founder of the Fire Victims Coalition a non-profit advocating on behalf of fire victims to receive full rebuilding cost from their insurance providers with no gap in coverage.

the dirt on drainage and soil preparation

The Dirt on Drainage and Soil Preparation

The Dirt on Drainage and Soil Preparation

Are you concerned about any of the following?

* A higher neighboring lot that cause water to flow onto your lot?
* Rainy-season drainage problems on your lot?
* Adding enough replacement soil to your lot?
* Who is going to do all of the above?

In the presentation that was shown at the 12/19/17 Area 4 meeting (http://bit.ly/CSAREA-4), page 27 (pictured here) includes the statement "Drainage on each lot must be verified by a civil engineer"
Slide from the Area 4 presentation on Dec. 19. Click to enlarge

Dealing with Drainage

In the presentation that was shown at the 12/19/17 Area 4 meeting (http://bit.ly/CSAREA-4), page 27 (pictured here) includes the statement “Drainage on each lot must be verified by a civil engineer”. Before actual construction can start, every lot must be checked by a civil engineer (from a company such as Hogan Land Services) to ensure that

(a) water that drains from the lot goes into the City storm drain, and

(b) water from OTHER lots does not go onto the lot being checked.

Contrary to rumor, the big builders ARE thinking about this — they HAVE to. The prohibition against water flowing from one lot to another is actually in the building code!

What actually happens is more than just “checking”. If there are drainage problems a civil engineer will design a drainage system that fixes the problems. This can include adding or removing soil, adding new underground pipes and surface drains, and changing the slope of the surface (by grading). The finished design appears on a page called the “Grading & Drainage Plan” in the final “permit package” that the builder must submit to the City for approval.

Regarding Infill

Sheepsfoot roller for soil compaction on heavy clay soil
Sheepsfoot roller for soil compaction on heavy clay soil

Regarding adding soil, page 27 in the above presentation also says “Infill soil must be added, compacted and tested”. (“Infill” is defined as “material that is used to fill a space or hole”; the term can also apply to a house built later on a lot that was left vacant when all the other houses in a development were built.)

Just like with drainage, adding soil isn’t as simple as it sounds and requires work by a civil engineer. Consider that if you have a typical 5,000 square-foot lot that has had 3″ of soil removed over the entire lot, that’s 8.7 cubic yards of soil — which is about 2/3 the capacity of an average commercial dump truck!

“Compaction” is like stomping on the soil to remove air and voids like you do after digging a hole, except that with clay soil like in Coffey Park it’s typically done with a piece of equipment called a “sheepsfoot roller”. Then compaction testing ensures that the soil has been compacted enough to support the weight of the foundation and house. Also note that wet soil (“mud”) can’t be tested for compaction, so the weather must be factored into this process.

Discuss soil plans with your builder

Many large builders will include infill , drainage and grading in their package, but smaller or custom builders might not. The whole “adding soil during construction” process is something that can’t be done by homeowners, so any talk about “sharing costs” doesn’t actually make sense when it comes to adding soil. What homeowners SHOULD do is (a) make sure that their builder’s plans reflect the homeowner’s specific desires before the builder submits them to the City, and (b) monitor what’s being done during the “preparation for building” phase (see pages 25-29 in the Area-4 meeting presentation) to make sure that visually obvious problems such as height differences between lots are being corrected.

Cooperate and coordinate with neighboring lot owners

It may be obvious, but correcting height differences between lots typically requires grading across multiple lots. This means that if even if you already have selected your builder/contractor and you’re highly focused on rebuilding your house, you still may need to cooperate closely with the owners of the lots surrounding yours. Networking with your neighbors through CoffeyStrong, Nextdoor and Facebook has never been more important!

Soft costs – are they included in the builder’s cost per square foot?

“Preparation for building” costs such as geotechnical (soil) testing, infill soil, drainage design, and lot-line surveying are often called “soft costs” because they’re not a direct (“hard”) construction cost. Soft costs are often included in the builder’s cost-per-square-foot quote, but not always. For example, take a look at the “Large Builder Matrix” on the CoffeyStrong website. Six of the seven builders shown in the table include soft costs, but one doesn’t. Make sure you ask your builder to explain in detail (in advance!) any and all costs that are not included in his cost-per-square-foot quote.

Keep learning to protect your interests

I’m fairly sure that the majority of you have never had to deal with construction at this level before, and it can be pretty intimidating. Just be thankful that you live in the Internet age! Google and Wikipedia are your new best friends. To protect your interests when dealing with builders, it’s really helpful to increase your understanding of construction terms. I suggest Googling and/or looking in Wikipedia for all the construction terms used above: drainage, civil engineer, building code, soil compaction, sheepsfoot roller, foundation types, grading land, geotechnical engineering, surveying lot lines, and soft costs. Happy reading!

posted 12.28.17 by Geoff Walker, CoffeyStrong Area 4 organizer & block captain
and Nextdoor Coffey Park Lead

this article is modified from a post on Nextdoor Coffey Park